Because it is not easy to breed long-haired rabbits, artificial insemination technology can not only improve the conception rate but also save time and effort, but also reduce the spread of disease, and can make full use of high-yielding breeds of male and female rabbits.

Insemination preparation

A microscope (200 times), a spermatozoa, hormones, slides, coverslips, saline, promote row No. 3, a collection of sperm.

The production of the picker is made of a hard plastic tube with a diameter of 5 cm and is cut into a 6 cm section; the two ends are ground smoothly and a diameter of 1.3 cm in the center is drilled so that the bottle cap can be filled without leakage. The person uses a condom to cut off with a pair of scissors, put it into a plastic tube, turn it on both ends, put it on both ends of the plastic tube, and then tighten it with a rubber band so that it does not leak, and put another sterile sleeve inside. Used to collect male rabbit sperm.

Steps

1. Disinfection: Put the inner tube of the collection sperm, the insemination device and the empty needle into the disinfection box, disinfect it with boiling water for 15 minutes, and remove it after 15 minutes. Rinse the inner tube, the insemination device, and the empty needle with saline for 2-3 times. Good standby.

2. Breeding of rabbits: Shorten the hairs near the genitals of the male rabbits used for sperm extraction, pick the female rabbits ready for breeding, and inject 0.5 to 1 μg per rabbit.

3. Semen collection: Put the disinfected inner tube into the semen, add the semen with warm water of about 45 degrees, fill it up, plug it with a cork, and use a needle to poke it into the mouth and blow it with a mouth. Pressure. After the pressurization, put a small amount of salt water before the picker to lubricate. When the sperm is collected, an assistant grasps the female rabbit, the sperm extractor holds the sperm in the right hand, the male grasps the back of the male rabbit in the left hand, the spermator points at the penis of the male rabbit, and collects the male rabbit while waiting for the male rabbit to crawl the female rabbit. Semen. After harvesting, gently release the warm water from the harvester and do not splash water into the finish.

4. Microscope observation: Take a small amount of the original essence and place it on a slide glass. Use a cover glass pressed tightly under a microscope to observe. The vitality is good, the density is high, and the amount of seminal fluid can be diluted with normal saline by 10-15 ml. - 30 female rabbits, with good vibrancy and low density, can be diluted 3-5 ml for 6-10 female rabbits. Unqualified semen should not be used.

5. Insemination: The assistant grasps the female rabbit, and the pudenda faces upward. The insemination worker's left hand grips the female rabbit's tail with his index finger and middle finger, and turns his thumb down to open the female's genitalia. The right hand puts the spermatozoa into the spermatophore. Lightly inserted into the female rabbit's vagina, the depth of 7-8 cm, not too deep and shallow, deep little litter size, shallow pregnancy rate is low. The female rabbit is inseminated and is well documented.

Quantum Therapy Analyzer:

Work Systems of the Testing Room
1.  Keep the testing room clean and quiet, and pay attention to electrical safety.
2.  Before testing, metal and communication equipment on the tested person`s body should be removed for proper placement.
3.  Those who wear pacemakers are not appropriate for testing.
4.  During work, inspect whether the power supply and the testing system are in a good using condition.
5.  In the testing process, the operational regulation must be strictly observed.
6.  Out of work, cut off the power supply and clear up the used equipment and the tester to make them be in a good standby condition.


The Quantum Magnetic Resonance Analyzer replaces the need for ultrasonic, nuclear magnetic resonance or radiography for various health related conditions. Holding sensors in your palm simply, health data will be collected within minutes from various body systems. The magnetic resonance analyzer offers new advantages in the field of material analysis. It has been shown that the applicability of such an analyzer exceeds the range of tissue analysis and other medical applications. The magnetic resonance analyzer measures the degree and type of response of a matter under test, and by comparison with reference matter it assists in recognizing deviations from the desired response. The software interface has updated high technology that the operation is more convenient and faster. The main future is 2 languages in software in one machine, both with English and another language.

Quantum Therapy Analyzer

Quantum Therapy Analyzer

Quantum Therapy Analyzer,Quantum Therapy Machine,Quantum Health Scanner,Magnetic Therapy Machine

Shenzhen Guangyang Zhongkang Technology Co., Ltd , https://www.lighttherapymachine.com